I do not want two jobs to run at the same time.

mlvats · Post by **mlvats** » 16 Jul 2008 3:23

I do not want two jobs to run at the same time. These two jobs are in two different group and tables.
How can this be done in Control-M?

mauriziog · Post by **mauriziog** » 16 Jul 2008 3:39

There many ways !

1) Have two different start time from two jobs
execution panel
submit between, to fields

Lacoochee · Post by **Lacoochee** » 16 Jul 2008 4:13

You could also make the jobs dependent on the same quantitative resource.

Create a quantitative resource with a max value of one and then in each of the jobs make them dependent on that resource being available.

Hint: In the Control-M/EM GUI select Tools --> Quantitative Resources --> New ... go from there.

Walty · Post by **Walty** » 16 Jul 2008 4:30

Why you don't use the Control Resources to serialise your jobs ?

Control Resources indicates the resources required by the job during execution and the type of control (shared or exclusive)

mlvats · Post by **mlvats** » 16 Jul 2008 11:00

Thanks.everyone for the reply. i used Control Resource Parameters - Exclusive and it did work.

siipryasa · Post by **siipryasa** » 22 Jul 2008 1:44

The name of the resource is the same in the two jobs's you has win upper and lower case,

Best Regards

Rafael

I do not want two jobs to run at the same time.

I do not want two jobs to run at the same time.

Resource Exclusive or Share