sysout in -x|-v|-n view mode in solaris with 2.24.05 agent

Everything about Control-M agents installation or setup.
Post Reply
User avatar
philmalmaison
Nouveau
Nouveau
Posts: 1148
Joined: 08 Jun 2007 12:00
Location: Ile de France

sysout in -x|-v|-n view mode in solaris with 2.24.05 agent

Post by philmalmaison » 23 Jul 2007 2:13

does anybody now how to change sysout view mode on solaris controlm agent V 2.24.05
i mean wich parameter to set all the sysout from an agent to set -x|-v|-n mode accessible in 6.1.03 with CTM_PRM_SH_FLAGS and CTM_PRM_KSH_FLAGS ???

User avatar
Walty
Nouveau
Nouveau
Posts: 473
Joined: 20 Jan 2006 12:00

Post by Walty » 24 Jul 2007 4:30

Hi,

For Korn shells: To change the default switch from -x to -v add the following line to
the ag_config.dat file: CTM_PRM_KSH_FLAGS -v.
For Bourne shells: To change the default switch from -v to -x add the following line
to the ag_config.dat file: CTM_PRM_SH_FLAGS -x.

Regards
Salutations
Walty

User avatar
mauriziog
Nouveau
Nouveau
Posts: 807
Joined: 08 Jun 2007 12:00
Location: Varese - Italy
Contact:

Post by mauriziog » 24 Jul 2007 5:01

Look at table 13 at page 57 of the "Agent administration guide" version 6.3.

There are some settings of the OS configuration on the agent platform running the utility: ctmunixcfg

I copy here some entries:
"
Korn Shell Flags
Indicates the shell flag that will be used to run the job script. For more information, see ?Specifying the shell type? on page 32.
Valid values: -x, -v, n. Default: -x

Bourne Shell Flags
Indicates the shell flag that will be used to run the job script. For more information, see ?Specifying the shell type? on page 32.
Valid values: -x, -v, n. Default: -x
"
Hope that this help you

User avatar
philmalmaison
Nouveau
Nouveau
Posts: 1148
Joined: 08 Jun 2007 12:00
Location: Ile de France

agent problems

Post by philmalmaison » 24 Jul 2007 5:10

hy,
it is possible to set an agent in 2.24.04 / 2.24.05 version to SYSOUT in JOBNAME mode ??

User avatar
mauriziog
Nouveau
Nouveau
Posts: 807
Joined: 08 Jun 2007 12:00
Location: Varese - Italy
Contact:

Post by mauriziog » 24 Jul 2007 5:20

I dont know, but if is possible you can do it by the utility:
ctmunixcfg (for unix) or ctmwincfg (for windows) or the equivalent v 2.24 utility.

User avatar
Walty
Nouveau
Nouveau
Posts: 473
Joined: 20 Jan 2006 12:00

Post by Walty » 25 Jul 2007 10:13

I've tried with an agent 2.24 (Solaris) to put this parameter <SYSOUT_NAME JOBNAME> in agconfig.dat but it was ignored.
Perhaps is not supported in this version.
I suggest to use the <sysout handling> with option <Copy> to force the JOBNAME in the sysout creation.

Regards
Walty

Post Reply