Hello,
Is someone has tried to install controlM agent 6.4.01.200 on Windows 2008 R2 64 bits in a cluster mode ? If yes what are the different steps to do.
Our conf : 2 nodes : nodeA and NodeB. Each node have a system install and we have a disk which is moving sometimes from nodeA to NodeB.
What we have done is :
installing an agent 6.4.01 on nodeA on C: disk
installing an agent 6.4.01 on node B on C: disk
installing FP 6.4.01.200 on nodeA and nodeB
When we start the agent on nodeA --> agent available from CCM menu
When we switch the agent to nodeB --> agent is unavailable from CCM menu.
I have made some researches and I have seen that people are talking about media 94183 to install but I am not so familiar with EDP and I do not know how to use it.
Help is very welcome.
Thanks for your reply.
Bucheron74.
ControlM agent 6.4 install on W2008 R2 in a cluster mode
- bucheron74
- Nouveau
- Posts: 6
- Joined: 16 Dec 2008 12:00
- bucheron74
- Nouveau
- Posts: 6
- Joined: 16 Dec 2008 12:00
ControlM agent 6.4 install on W2008 R2 in a cluster mode
Hello Mauriziog,
Thanks for your reply.
I have found how to install it in a cluster mode using agent downloading from EPD site, then using cluster_group mode.
Best regards.
Thanks for your reply.
I have found how to install it in a cluster mode using agent downloading from EPD site, then using cluster_group mode.
Best regards.