Is there a Character limitation on commands in Control M?

Everything about Control-M agents installation or setup.
Post Reply
TRAVO

Is there a Character limitation on commands in Control M?

Post by TRAVO » 06 Jul 2007 9:07

Is there a character limit for ISeries jobs submitted via Control M version 6.2.01? We have a job that runs ok on a couple other ISeries successfully but on one particular system the command is being cut off at 200 characters and the job fails right away. Is there a setting on the agent side? Here's the command it's two lines


1. CHGJOB LOG(4 00 *SECLVL) LOGCLPGM(*YES)

2. PSAUDIT/STRAAAPI REPORT(AA2000C) LIBRARY(RFS) FROMDATE(*PRVDY) TODATE(*PRVDY) PRINT(*) COUNT(0) RELOAD(N) QRY(DEFAULT) OFILE(*NONE) OLIB(QGPL) OPT(*REPLACE) RUNI(*YES) OUTQ(NETIQRPTS)

Thanks,

User avatar
fyot
Nouveau
Nouveau
Posts: 736
Joined: 26 Apr 2005 12:00
Location: PARIS
Contact:

Post by fyot » 07 Jul 2007 11:41

Hi TRAVO,

I don't know anything about ISeries.

So, CMDLINE parameter is a BLOB field in the Control-M database.
BLOB field is like a TEXT field and the the limit concerns only how the database server is configured.

So if that command doesn't run only on one ISeries it could be an ISeries limit configured on it.

User avatar
mauriziog
Nouveau
Nouveau
Posts: 807
Joined: 08 Jun 2007 12:00
Location: Varese - Italy
Contact:

Post by mauriziog » 24 Jul 2007 9:06

From the documentation of 6.2. version:
"commad line": Length 1 through 512 characters.

Because 200 chars is under this limit, i think that is true what suggest "fyot": "could be an ISeries limit configured on it."

Post Reply