There is an installation issue with Control-M Agent setup.
When Control-M Agent setup finished to install components it should modify inetd.conf and restart service.
So, it's not the case with Solaris 10, and the Control-M agent didn't start.
All inetd.conf information are now loaded in a database.
To solve that issue you must to restart manually inetd.conf.
Launch following command to load new inetd information in the database:
inetconv -i /etc/inetd.conf
Control-M Agent with Solaris 10
- philmalmaison
- Nouveau
- Posts: 1148
- Joined: 08 Jun 2007 12:00
- Location: Ile de France
- philmalmaison
- Nouveau
- Posts: 1148
- Joined: 08 Jun 2007 12:00
- Location: Ile de France