We are building out new servers on Linux Redhat EL 5 & I need to konw if ControlM agents can run on RH 5. Does anyone have experiece with this?
Ideally we want to go with Ctm agent 6.3
thx,
Bob
Will ControlM agent run on Linux RH 5?
I've installed a full Control-M 6.4 environment with all latest fixpacks on RHEL 5 Server
Also installed full Control-M 6.3 (Sybase) environment with latest fixpacks on RHEL 4 AS with no worries.
I'm sure 6.3 will have no problems going on RHEL5 just make sure Check_Req.sh is happy otherwise you might have problems in the middle of installation.
The only thing I needed to do was set "uname -n 2048" and kernel.shmmax = 2147483648
this was all done on a VM with only 512MB of Memory and x86 processor.
Also installed full Control-M 6.3 (Sybase) environment with latest fixpacks on RHEL 4 AS with no worries.
I'm sure 6.3 will have no problems going on RHEL5 just make sure Check_Req.sh is happy otherwise you might have problems in the middle of installation.
The only thing I needed to do was set "uname -n 2048" and kernel.shmmax = 2147483648
this was all done on a VM with only 512MB of Memory and x86 processor.