Hello,
Sometimes there will be an error in an ON statement in the STEPS tab. The entire block then does not execute. Where can I see what the error was? In a log somewhere?
CTMLOG only shows what executed correctly and not errors or why error occured.
Thank you -- Goo
Steps Errors - Where to Find Error Explanation
Re: Steps Errors - Where to Find Error Explanation
Hi Goo
Don't forget this.
On Statement process is to parse sysout and detect your message.
But comparison is case sensitive, and if only one character is different, the block to be detected will not be the same.
Don't forget this.
On Statement process is to parse sysout and detect your message.
But comparison is case sensitive, and if only one character is different, the block to be detected will not be the same.