BMC Scheduler cannot read the shutdown command.

TRAVO · Post by **TRAVO** » 05 Jun 2007 10:17

BMC Scheduler cannot read the shutdown command. This apparently has never worked through BMC, as the shutdown would work, but it would not recognize the restart flag on the shutdown.exe command. Is there any help on this to allow Control M the ability to reconize the restart flag on the shutdown.exe command? The server that is needed to be rebooted is a E.piphany server.
Here is an example of the command I am using.

D:\Data\Tools\Shutdown.exe /L/C/R

Automated reboots of the Epiphany 5.5 DSCS Servers

Thanks,

Travo

Post by **fyot** » 05 Jun 2007 11:35

Hi TRAVO

I just will try the following syntax :

cmd /C "D:\Data\Tools\Shutdown.exe /L/C/R "

TRAVO · Post by **TRAVO** » 06 Jun 2007 3:56

I can use that exact syntax in a job as a command?

Thanks,

Travo

Post by **fyot** » 06 Jun 2007 4:00

You can launch almost evrything with Control-M.

TRAVO · Post by **TRAVO** » 06 Jun 2007 4:05

Thanks I will try that command to see if it works. Do I leave the quotes and the spaces just as you have them in your response?

Thanks,

Travo

Post by **fyot** » 06 Jun 2007 4:10

Yes, try exactly the same syntax. Simple quote could not run correctly.