Load balancing in CM Unix Cluster

Everything about Control-M eTrigger
Post Reply
User avatar
gglau
Nouveau
Nouveau
Posts: 317
Joined: 13 Jun 2007 12:00

Post by gglau » 16 Oct 2007 10:08

Yes, this should work if what you mean by load balancing of agent is between active node (A or B) and node C. Control-M does not distingush virtual node from physical node.

User avatar
philmalmaison
Nouveau
Nouveau
Posts: 1148
Joined: 08 Jun 2007 12:00
Location: Ile de France

Post by philmalmaison » 17 Oct 2007 11:51

yes because load balancing is another concept.

User avatar
mauriziog
Nouveau
Nouveau
Posts: 807
Joined: 08 Jun 2007 12:00
Location: Varese - Italy
Contact:

Post by mauriziog » 23 Oct 2007 4:28

For load balancing in general see the quantitative resources with the "@".
IF you want to do so in a cluster you must install agents not in cluster mode but in each node. And than you can do load balancing.

User avatar
mauriziog
Nouveau
Nouveau
Posts: 807
Joined: 08 Jun 2007 12:00
Location: Varese - Italy
Contact:

Post by mauriziog » 25 Oct 2007 9:18

ronald wrote: As mentioned above, I want to setup a load balancing via a NODEGROUP
definition. And one member of the group is a virtual host (HACMP configurations) and the other member is an independent agent machine(not in cluster mode).
Now I understand and in the configuration that you have the load balancing works fine. Put in the NODEGROUP the virtual host name and also the others indipendent agent machines, configure the quantitative resources as explained in the documentation and it works fine.
I use it in a windows cluster with others agents.

Post Reply