Page 1 of 1
Set tab
Posted: 22 Jan 2012 7:39
by Gopikkd
Can anyone please explain about set tab in Job Editing form in Control-M/EM GUI.
Thanks in advance !!!
Posted: 29 Jan 2012 10:30
by processing
This is where Auto-Edit variables are defined. Auto-Edit variables are a somewhat complex topic, because there are a lot of them, and they display varied behavior.
A good place to start is the
Control-M User Guide. If you want to jump right into Auto-Edit variables, flip to p. 87, which takes you to the following section:
Part 2 - Defining the production environment > 4 Defining how jobs should run > Creating and editing jobs > Defining and using variables that are dynamically resolved at runtime