Set tab

Post Reply
User avatar
Gopikkd
Nouveau
Nouveau
Posts: 154
Joined: 25 May 2009 12:00
Location: Bangalore

Set tab

Post by Gopikkd » 22 Jan 2012 7:39

Can anyone please explain about set tab in Job Editing form in Control-M/EM GUI.

Thanks in advance !!!

processing

Post by processing » 29 Jan 2012 10:30

This is where Auto-Edit variables are defined. Auto-Edit variables are a somewhat complex topic, because there are a lot of them, and they display varied behavior.

A good place to start is the Control-M User Guide. If you want to jump right into Auto-Edit variables, flip to p. 87, which takes you to the following section:

Part 2 - Defining the production environment > 4 Defining how jobs should run > Creating and editing jobs > Defining and using variables that are dynamically resolved at runtime

Post Reply