Hello Friends,
I am new to this forum and to Control M. I have requirement where I will have to send Email after completion (OK) of some specific jobs in my trail. Close to 8 jobs individually.
currently my team is doing this manually and wanted to know if the same can be automated through Control - M.
These jobs are jobs in different groups and last jobs of a major subsystem in my job flow. Thanks for your help.
Option to send Email from Control M for specific jobs
- Techtronic
- Nouveau
- Posts: 3
- Joined: 06 Dec 2011 12:00
- Techtronic
- Nouveau
- Posts: 3
- Joined: 06 Dec 2011 12:00
Thanks Markf.
The version we are using is 7.0.00. The Control M is also maintained by another vendor and they are not able to configure email and I also do not have access to manually verify anything or configure.
It would greatly help, if you could guide with steps to set up the email for specific jobs.
The version we are using is 7.0.00. The Control M is also maintained by another vendor and they are not able to configure email and I also do not have access to manually verify anything or configure.
It would greatly help, if you could guide with steps to set up the email for specific jobs.
Option to send Email from Control M for specific jobs
Goto Steps tab in the Job Editing Form.
Give the below values.
On stmt=* Code=COMPSTAT=0
Do Mail To=XXXXXXX Subject=XXXX Msg=XXX Details=
Give the below values.
On stmt=* Code=COMPSTAT=0
Do Mail To=XXXXXXX Subject=XXXX Msg=XXX Details=
Hello,
You first need to configure the SMTP protocol on CTM-Server.
In ctm_menu -> 5->6 "Simple Mail Transfer Protocol Parameters"
and theryou must fill the parameter:
Simple M ail Transfer Protocol Parameters Menu
----------------------------------------------
Select one of the following options:
1 - SMTP Server (Relay) Name : xxxx
2 - Sender Email : xxxxx
3 - Port Number : 25
4 - Sender Friendly Name : xxxxx
5 - Reply-To Email : xxxxx
6 - Test SMTP Settings
s - Save Parameters
After you done this, you can use the on/do statement "do mail".
regards
Vassilis
You first need to configure the SMTP protocol on CTM-Server.
In ctm_menu -> 5->6 "Simple Mail Transfer Protocol Parameters"
and theryou must fill the parameter:
Simple M ail Transfer Protocol Parameters Menu
----------------------------------------------
Select one of the following options:
1 - SMTP Server (Relay) Name : xxxx
2 - Sender Email : xxxxx
3 - Port Number : 25
4 - Sender Friendly Name : xxxxx
5 - Reply-To Email : xxxxx
6 - Test SMTP Settings
s - Save Parameters
After you done this, you can use the on/do statement "do mail".
regards
Vassilis
- Techtronic
- Nouveau
- Posts: 3
- Joined: 06 Dec 2011 12:00
Thanks Gopikkd and Vassi168. I have passed on to my Vendor team.
From one of the persons, I got to know that control-m (version 7) has been moved to windows server (ATOS Control-m in AIX server) and there SMTP server is not installed in the windows server.
I am afraid that I will not be able to automate the manual work that is being done by the team.
From one of the persons, I got to know that control-m (version 7) has been moved to windows server (ATOS Control-m in AIX server) and there SMTP server is not installed in the windows server.
I am afraid that I will not be able to automate the manual work that is being done by the team.