Job completes successfully however not ok

raven · Post by **raven** » 07 Sep 2009 1:16

Hi,

I have been seeing this for a past few days, that though the job executes successfully, the status of the job goes to red(NOT OK). Unsure why this could be happening.

Any help appreciated.

- Raven

philmalmaison · Post by **philmalmaison** » 07 Sep 2009 2:30

as you know, not ok is the result of a non zero return code from the script somewhere.
how did you ensure about the returned code ?
can you remember about the sysout and the log of the job at this particular moment ?

what did you code as on do statement ?

regards
philmalmaison

samirniljikar · Post by **samirniljikar** » 17 Sep 2009 4:51

As mentioned in the earlier reply,please check if there is an Do ReRun statement in the Steps.Plus if there is an incorrect condition put like Compstat ! 0 in the Alert to ECS step.Also,Is the job setup to Auto rerun?On Control-M for a non-cyclic job to Auto-Rerun,it first has to be in Failed State.Hence regardless of the job being Ended ok