Hi CTM guru,
Ive just install Control-M version 6.3.0.1 from scratch, the previous CTM version is 6.1.03.
After installing the new version, I found that all the control-M drafts which created by version 6.1.03 is unable to use in 6.3.0.1 anymore.
When I wrote the draft(version 6.1.03) to CONTROL-M, it throw the following error:
Is there any tools could convert the draft from version 6.1.03 to 6.3.0.1?
how to convert draft from version 613 to 630
Hi fyot,fyot wrote:In fact,
Draft version 6.1 are not compatible with version 6.3.
The only way will be to keep an old version of Control-EM 6.1 only to read the draft and export with XML format.
XML is totaly compatible to be load with 6.3.
Could you by any chances specify how to export the draft to a xml file?
Do you mean that using the migration toolkit?
Go to that post concerning exportdeftable utlity.
- philmalmaison
- Nouveau
- Posts: 1148
- Joined: 08 Jun 2007 12:00
- Location: Ile de France
Hi Ronald,
Mauriziog had totally right about migration tool kit.
In fact, migration could be done with different way.
To depend on what do you want to migrate.
If migration concerns all Control-m components, migration tool kit is the best way.
Now, if you migrate step by step, or only some existing jobs but not all, and all others possibilities, you can use xml import and export utilities.
Mauriziog had totally right about migration tool kit.
In fact, migration could be done with different way.
To depend on what do you want to migrate.
If migration concerns all Control-m components, migration tool kit is the best way.
Now, if you migrate step by step, or only some existing jobs but not all, and all others possibilities, you can use xml import and export utilities.