Steps tab
Steps tab
this should work :
on the steps tab Do a "Stop Cyclic" for the 1st failure, also Do a "Force Job" and force in another run of the same job(you may have to alter the job name slightly). If it fails again Do another "Stop Cyclic" and send the notifications. If it's OK it will just keep running
on the steps tab Do a "Stop Cyclic" for the 1st failure, also Do a "Force Job" and force in another run of the same job(you may have to alter the job name slightly). If it fails again Do another "Stop Cyclic" and send the notifications. If it's OK it will just keep running
Re: Steps tab
1. OnGopikkd wrote:Could you please tell me On/Do statement and Parameters values for this?
statement *
Code NOTOK
Do
Stop-Cyclic
Force Job - Table Name - Job name etc.
For second job.
On
statement *
Code NOTOK
DO
Stop Cyclic
mail and the info