Good day,
I have read the 'Gen Alarm' topic and would like to know, is there a way to email the 'Very Urgent' alerts that are displayed in the GAS to a specific email address? Not everyone has setup shouts so I would like to receive alerts on job failures, etc.
Thanks
Andrew
Emailing Alerts from the GAS
Hi,
If you don't want to use DO SHOUT, you can use SNMP Forward.
Using Administration Facility or Configurtion Manager (6.3.01) you can modify System Parameters.
Those parameters give you some possibilities to forward all GAS messages. You must modify following parameters:
Bmc documentation
SendAlarmToScript
Full path name of the script that is activated when an alert is generated. This script is activated only if the value of SendSnmp is either 1 or 2. Default: script_name
SendSnmp Indicates where Alert data is to be sent. Valid values:
0 ? SNMP only (default)
1 ? User-defined script only
2 ? SNMP and user-defined script
SnmpHost
Host name for SNMP alerts. Default: no_host
SnmpSendActive
SNMP messages for Active Alerts are (1) or are not (0) generated.
Default: 0
SnmpSendDemo
SNMP messages for Demo Alerts are (1) or are not (0) generated.
Default: 0
SnmpSendFormat
Determines the SNMP message format.
0 ? Single Variable format
1 ? Multiple Variable format
2 ? Both formats (default)
You will find snmp information in Control-EM Adminidration Guide.
If you don't want to use DO SHOUT, you can use SNMP Forward.
Using Administration Facility or Configurtion Manager (6.3.01) you can modify System Parameters.
Those parameters give you some possibilities to forward all GAS messages. You must modify following parameters:
Bmc documentation
SendAlarmToScript
Full path name of the script that is activated when an alert is generated. This script is activated only if the value of SendSnmp is either 1 or 2. Default: script_name
SendSnmp Indicates where Alert data is to be sent. Valid values:
0 ? SNMP only (default)
1 ? User-defined script only
2 ? SNMP and user-defined script
SnmpHost
Host name for SNMP alerts. Default: no_host
SnmpSendActive
SNMP messages for Active Alerts are (1) or are not (0) generated.
Default: 0
SnmpSendDemo
SNMP messages for Demo Alerts are (1) or are not (0) generated.
Default: 0
SnmpSendFormat
Determines the SNMP message format.
0 ? Single Variable format
1 ? Multiple Variable format
2 ? Both formats (default)
You will find snmp information in Control-EM Adminidration Guide.