Be careful about what port numbers you are using. Some versions of AIX consider 7000 series ports to be reserved for AIX.

What was the official date that 6.1.03 went out of support?

I set up a way to put all jobs on hold, by ensuring that all jobs have a quantative resource called Job or Schedule in them, each using 1. The QR is used by the entire schedule, so I set it to around 1000. When I want to stop the world, I set it to zero, and anything that wants to run turns blue unt...

I actually dumped it to xml and then deleted it from the database entirely and then put it back in using deftable, and got the same issue.

I have one scheduling table that the user daily loads every day no problem, but I can not forecast it anymore.

I get failed to get simulation results, and the viewpoint closes.

I am at a loss to figure out what is wrong with it

Any suggestions?

I am trying to build a group schedule with 16 jobs in it. Each of these jobs specifies a node group in its definition that represents 4 servers. What I want is for all16 jobs to run on all 4 servers. The number of jobs and servers will increase eventually to 24 jobs on 20 servers, and I need to run ...

Hello Folks. Has anyone ever had this problem? I am running in a 6.2.01 fp4 environment. We run a stream of jobs to completion. Client discovers that some data was not input before hand. We go to rerun the job stream. All pre requisite conditions are deleted for that ODATE We go to rerun things and ...

I know how to stop one and start one. My concern is if there is a maximum number of times you can run a cyclic job without causing Control-M problems. I need to run this thing every 2 minutes from 0745 to 1700 every day. If there is a max number, I will just create a couple of jobs and break the str...

I have a job that will need to run every 5 mins almost all day.

Is there a limit to the number of times a job can run without breaking.

If I need to break it up into two or three consecutive jobs, say 200 each, I can do that.

Anyone know for sure?

I will give this a try and see what I get.

Thanks, but I dont have access to the knowlege base at the moment, due to the way we are supported via an outsouce situation.

Any chance I could get a copy of that article emailed to me?

Hi folks.

I am trying to start the reporting facility to generate a very simple report, and when I try to start it I get

The application failed to get the databae parameters from the MCS.Ini file
Check the logs for more information.

Any ideas on how to fix this?

Thanks.